Publicité
All manuals and user guides at all-guides.com
Balkenmaeher_468426.book Seite 46 Mittwoch, 6. April 2016 3:14 15
GB
After each use
What?
How?
► Cleaning the prod-
Cleaning the de-
vice
uct – p. 46.
Every 25 hours of operation
What?
How?
► Cleaning/replacing
Cleaning the spark
plug
the spark plug – p. 46,
All 100 operating hours or once in year
What?
How?
► Cleaning/replacing
Cleaning/replac-
ing the spark plug
the spark plug – p. 46,
Replacement spark
plugs: ► Technical da-
ta – p. 48.
Every 200 operating hours or every 12
months
What?
How?
Check the fuel line To be carried out by an
approved workshop!
Cleaning the product
NOTICE! Risk of product damage!
Never clean device with high pres-
sure cleaner.
Never use aggressive detergents or
solvents for cleaning.
– Remove any adherent dirt.
– Clean engine with cloth and brush.
Cleaning/replacing the spark plug
DANGER! Risk of injury due to
high-voltage! Do not touch the igni-
tion cable connector and spark plug
while the motor is running.
NOTICE! Risk of product damage!
Fit the spark plug only when motor is
cold.
Replace the spark plug only with a new spark
plug of the same type (► Technical data –
p. 48).
► P. 4, item 2
– Pull off the ignition cable connector (18).
– Unscrew the spark plug.
Cleaning the spark plug
– Remove rust from the electrode with a
wire brush with brass bristles.
46
NOTICE! Risk of product damage!
To clean the spark plug, use only
wire brushes with brass bristles.
Bristles of any other material will
damage the electrode!
Replacing the spark plug
► P. 4, item 2
– Insert a cleaned or new spark plug and
tighten by hand.
– Hand-tighten the screwed-in spark plug,
then use the spark plug wrench to firmly
tighten by another quarter turn, tightening
any more will damage the threads.
– Replace the ignition cable connector
firmly on the spark plug.
Checking the motor oil level
► P. 4, item 2
– Unscrew and remove the motor oil filling
plug (13).
– Read-off the oil level on the dip stick on
the underside of the motor oil filling plug.
– The oil level must be between the two
arrows.
Check clutch for travel drive
– Engage clutch lever for travel guide (4) up
to the stop while pushing the device.
– If the wheels do not get blocked in case
of engaged clutch lever, the cable pull of
the travel guide clutch must be tightened
(► Set clutch cables – p. 46).
Set clutch cables
► P. 7, item 9
► P. 8, item 10
The clutch cables can be tensioned and
relaxed by means of the respective adjusting
screws (21, 22).
Set tyre pressure
DANGER! Risk of injury! Risk of
explosion! Never exceed maximum
tyre inflation pressure of 1.4 bar!
Recommended tyre pressure: approx. 1 bar.
Storage and transport
Storage
WARNING! Risk of injury! Make
sure that unauthorized persons do
not have access to the product!
Publicité
