Publicité
Video entry system
In a system with one ETI/SER XIP and several ETI-XIP gateways, the ETI/SER XIP must be the master and will be the first to be programmed.
Device mode
Under [Video entry system] in the [Device mode] tab, choose a communication port through which slaves will communicate with the ETI/SER XIP Master (permitted range:
20050-20166). Unless otherwise indicated, set to 20050.
It shows the IP address and port through which the slaves communicate with the backup (where applicable), if communication with the master is temporarily interrupted.
Once you have finished, press [Save].
Video entry system
General information
Device mode
Device data
Network
Type
Date and time
VoIP settings
Master IP address
Access control
Master port
Video entry system
Credentials
Backup IP address
Forwards and diversions
Backup port
Licences
Maintenance
Diagnosis
Slaves
Under [Slaves], add slave devices (if any) to the system. Press [Add new slave]. If the slaves are correctly configured and connected to the network, the server will
automatically populate this table.
Video entry system
General information
Device mode
Device data
Network
Date and time
VoIP settings
Access control
Video entry system
Credentials
Forwards and diversions
Licences
Maintenance
Diagnosis
In the window that appears, enter the name of the slave device and the IP address.
Once you have finished, press [Save].
To add another slave, repeat the procedure.
1
Slaves
Multiserver
Passages and video cameras
Slaves
Multiserver
Passages and video cameras
Status
Description
Add new slave
Save
Reload
IP address
No device found
Save
3
Add new slave
Description
IP address
Master
Backup
Delete
Reload
Save
2
User
User
Publicité
