Timberwolf TW 230VTR Manuel Opérateur page 70

DECALS
DECAL
C192‐0112
C190‐0114
DESCRIPTION
616
Warning.
Hot exhaust
617
Warning.
High velocity discharge ‐
keep clear
670
Personal Protective
Equipment required.
See page 5.
1661
Read the instruction manual
for greasing and
maintenance information.
1662
The instruction manual with
this machine contains
important operating,
maintenance and health and
safety information. Failure
to follow the information
contained in the instruction
manual may lead to death or
serious injury.
1399
Push safety bar to stop.
Do not pull here.
P691
Fuel Here.
Risk of fire. Allow engine to
cool for 1 minute before
refuelling.
Use diesel fuel only.
P1301
Push to stop,
Pull to reset.
(engine)
19518
When the engine stop
button is pressed it must be
pulled out again and the
ignition switch turned off to
reset the machine before
attempting to restart.
29 / 64
DECAL
26.06.2018
TW 230VTR
DESCRIPTION
4099
Danger.
Rotating blades.
Keep hands and feet out.
2800
Reverse feed
2801
Forward feed
Warning. Do not engage starter
19517
motor for more than 20 seconds.
Allow one minute before
attempting to start. Investigate
reasons for failure to start.
Excessive cranking will result in
starter motor failure. This will
not be covered under warranty.
Lifting eye is designed to lift the
2949
machine's weight only. Do not
use hoist hook directly on lifting
eye. Use correctly rated safety
shackle only through lifting eye.
Lifting eye to be inspected every
6 months or before each use.
Always visually inspect lifting eye
prior to each use. Do not use
lifting eye if damaged.
3022
Clean under blades before
refitting or turning. Failure to do
so may result in blade(s) coming
loose and damage being caused
to the rotor housing.
18393
New drive belts need re‐
tensioning.
When new belts are fitted check
tension every 2‐3 hours & adjust
until tension remains constant.
P1812
Torque blade bolts to 125 lbs ft
(170 Nm).
1745
Track
Chip
17450
Select Chip mode when adjusting
track width.
Rev: 2.0