Publicité
2. handle
3. Water Tank
4. Filter Box
5. outlet
6. Drain
7. Supply Cord
8. Hang line buckle
9. Caster
► P. 2, fig. 2
1. [POWER]
2. [MIRAGE]
3. [FILTER]
4. [FAN SPEED]
5. [MODE]
6. [TIMER]
Supplied as standard
• Air dehumidifier
• Filter
• Instructions for use
Note: If a part is missing or damaged,
please contact the vendor.
Features
Powerful Dehumidifying Capability
Taking advantage of refrigeration technology, the
dehumidifier powerfully removes moisture from the
air to decrease the humidity level of the room and
keep the indoor air dry and comfortable.
Lightweight Portable Design
The dehumidifier is built to be compact and light-
weight. The casters on the bottom of the unit make it
easy to move from room to room.
Low Temperature Operation with Automatic
Defrost
After the continuous operation of the compressor for
10min and during the continuous operation of the
compressor, when the coil temperature is detected to
be ≤-5 °C, the compressor immediately stops and the
fan forces the operation with high wind. After that,
when the coil temperature ≥2 °C was detected for
3min continuously, the anti-frosting was withdrawn,
and the press and fan returned to normal.
Adjustable Humidistat
Different dehumidification levels can be selected
according to different room requirements.
Timer On/Off
Program the unit to turn on and off automatically.
Quiet Operation
The dehumidifier operates with a low noise level.
Energy Efficient
The power consumption of the unit is low.
Setting up
► Commissioning – p. 3
NOTICE! Risk of product damage! The
product must be installed in an upright
and stable position.
– Maintain the minimum clearance around the
dehumidifier when the unit is operating as shown
in the drawing.
– Position the product in the room centre to ensure
optimum air circulation.
– Do not position the product close to radiators or
other heat sources.
– Keep window and doors closed in rooms to be
dehumidified.
– Avoid repeatedly entering and leaving rooms to
be dehumidified.
– The product is intended for room temperatures of
5–35 °C.
– Leave the product to stabilise for a few minutes
after installation.
Operation
Check before switching on!
DANGER! Risk of injury! The product
may only be put into operation if no faults
are found during the check-up. It is crucial
that any defective parts are replaced
before the product is used again.
Check the safe condition of the product:
– Check whether there are any visible defects.
– Check whether the condensate tank is empty.
– Ensure that the condensate tank is correctly
inserted.
Note: At room temperatures below 5 °C
and a relative humidity below 35%, eco-
nomic product output is no longer guaran-
teed.
Functions
The product operates according to the condensation
principle.
• The fan sucks in the humid room air through the
intake filter.
• The room air is cooled to below the dew point and
the water vapour contained in the air precipitates
as condensate.
• The dehumidified, cooled air is then warmed back
up and blown out again at a temperature a few
degrees above room temperature.
Humidity Level & Timer 2 Digital Display
The indicator features 3 functions:
• When the unit is turned on, it will indicate the room
humidity level.
• When you set the humidity, it will indicate the
humidity that you have selected
• When you program the time for the unit to turn on
and off, it will show the hours.
• When the environment humidity is lower than
20%, it will show [20]
• When the environment humidity is higher than
90%, it will show [90]
Operating Instructions
1. The power display is all on, the static display is 3s
and off, only the [POWER] key supply light is on;
If it is the first time to power on, press
GB
35
Publicité
