Publicité
HTB200PP_DVQX2752ZAX1.book Page 12 Friday, August 2, 2024 3:03 PM
HDMI CEC
This unit supports "HDMI CEC" (Consumer
Electronics Control) function.
See the operating instructions for connected
equipment for operational details.
Preparation
Confirm that the HDMI connection has been made.
(
8, 9)
Power on link
When the TV is turned on, the unit also turns on
automatically. (This function does not work when
OPTICAL or Bluetooth
®
Power off link
When the TV is turned off, the unit also turns off
automatically. (This function does not work when
OPTICAL or Bluetooth
®
Volume adjustment
You can control the volume setting of this system
using the volume or mute button on the TV remote
control.
If the TV's speaker selection is changed to the TV
speakers, the unit's speakers are muted. Muting
will be cancelled by selecting the unit's speakers
again.
Changing speakers
When the unit turns on, this system will be
selected as the TV's speakers automatically.
When you turn off the unit, TV speakers will be
automatically activated.
Note:
The operation cannot be guaranteed on all HDMI CEC
equipment.
12
12
is the source.)
is the source.)
Troubleshooting
Before requesting service, make the following
checks. If you are in doubt about some of the
check points, or if the solutions indicated do not
solve the problem, consult your dealer for
instructions.
Common problems
█
No power
After connecting the AC power supply cord, wait
•
about 10 seconds before turning on the unit.
Disconnect the AC power supply cord for 10
•
seconds before connect again.
After turning on the unit, if the unit immediately turns
•
off, disconnect the AC power supply cord and
consult your dealer.
If the unit does not turn on when turning on TV
•
(HDMI CEC), turn on the unit manually.
No operations can be done with the remote
control.
Remove the insulation sheet before you use the
•
remote control for the first time. (
Examine that the battery is installed correctly. (
•
The battery is weak. Replace it with a new one.
•
(
7)
Set the remote control code again after replacing
•
the battery. (
14)
Use the remote control within the correct operation
•
range. (
6)
The system automatically turned to standby mode
•
"Auto power down" function is on.
The system automatically turns to standby mode if
there is no signal input and no operation is being
performed for approximately 20 minutes. Refer to
page 11 to turn off this function.
Bluetooth
█
®
Pairing cannot be done.
Check the Bluetooth
device condition.
•
®
The device is out of the 10 m (33 ft) communication
•
range. Move the device nearer to the system.
The device cannot be connected.
The pairing of the device was unsuccessful. Do
•
pairing again.
The pairing of the device has been replaced. Do
•
pairing again.
This system might be connected to a different
•
device. Disconnect the other device and try
connecting the device again.
The system may have a problem. Turn off the
•
system and then turn on again.
7)
7)
Publicité
