Publicité
15
Model Fault
No boot
16
loader
Panel Flash
17
Fault
19
Same Serial
20
CAN Fault
BAT Volt
21
Different
Line Volt
22
Different
Line Freq
23
Different
Output Config
24
Different
Output Syn
25
Loss
Warning
alarm: the product does not enter the fault mode, the LED red light flashes, and the LCD displays the alarm
code
EN
Software
Fault mode
machine model is not matched
with hardware
detection
Fault mode
No guidance program
Fault mode VML model is burning the PV
control program
In the parallel machine mode,
Fault mode
the machine with the same
sequence number is
detected
In the parallel mode, the CAN
Fault mode
bus communication is
abnormal
In the parallel mode, the battery
Fault mode
pressure difference between
different machines
is too large
In the parallel mode, the input
Fault mode
pressure difference between
different machines
is too large
In the parallel mode, the
Fault mode
frequency of different machines
input voltage
difference is too large
In the three -phase merger
mode, there is a lack of phase
Fault mode
settings in different machine
parallel mode settings
In parallel mode, the output
Fault mode
voltage detection is lost
synchronization
Alarm code table
recognition
Cannot recover
Cannot recover
Recovery after the
burning
recording
Cannot recover
Cannot recover
Cannot recover
Cannot recover
Cannot recover
Set as a single
machine
run
meet the three
-phase operation
setting
conditions.
Cannot recover
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Fault
or
Fault
Fault
Publicité
