Publicité
WARNING! or CAUTION! or REMEMBER! Applicable to the given situation. (general
warning sign).
ATTENTION! Electric shock warning!
Class II protection device with double insulation.
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some details
may differ from the actual machine.
2. Usage safety
ATTENTION! Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in an electric shock, fire and/or serious injury or even death.
The terms „device" or „product" are used in the warnings and instructions to refer to
Platform scale.
Do not use in very humid environments or in the direct vicinity of water tanks. Prevent the device
from getting wet. Do not touch the device with wet or damp hands.
2.1.
Electrical safety
For battery charger
a) The plug must fit the socket. Do not modify the plug in any way. Using original plugs and
matching sockets reduces the risk of electric shock.
b) Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device is exposed to rain, comes into direct
contact with a wet surface or is operating in a damp environment. Water getting into the
device increases the risk of damage to the device and of electric shock.
c) Do not touch the device with wet or damp hands.
d) Use the cable only for its designated use. Never use it to carry the device or to pull the plug
out of a socket. Keep the cable away from heat sources, oil, sharp edges or moving parts.
Damaged or tangled cables increase the risk of electric shock.
e) If using the device in a damp environment cannot be avoided, a residual current device (RCD)
should be applied. The use of an RCD reduces the risk of electric shock.
f) Do not use the device if the power cord is damaged or shows obvious signs of wear. A
damaged power cord should be replaced by a qualified electrician or the manufacturer's
service centre.
g) ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in water or other
liquids.
2.2.
Safety in the workplace
a) Make sure the workplace is orderly and well lit. A messy or poorly-lit workplace may lead to
accidents. Try to think ahead, observe what is going on and use common sense when
working with the device.
b) If there are any doubts as to the correct operation of the device, contact the manufacturer's
support service.
c) Only the manufacturer's service point may repair the device. Do not attempt any repairs
independently!
EN
Publicité
