Publicité
COMMUNICATION SYSTEMS
(Available as an accessory / replacement
part)
Your helmet is designed to be equipped
with the SENA FOR SHARK (Bluetooth or
Mesh) communication system.
If your helmet is approved according to
UNECE Regulation No. 22-06, it has also
been tested and approved with SENA FOR
SHARK (Bluetooth or Mesh) installed.
The installation of a system other than
SENA FOR SHARK (Bluetooth or Mesh)
compromises the regulatory compliance
of the helmet. During the installation of
the communication system, see specific
instructions in the SENA FOR SHARK
(Bluetooth ou Mesh) kit.
INSTALLATION OF THE SENA FOR
SHARK SYSTEM
Your helmet is approved for SENA FOR
SHARK (Bluetooth or Mesh).
Follow these steps to install your
communication system.
1. To do this, remove the textile liner
according to the disassembly description
on page 19.
Remove the white Styrofoam PAD in the
space provided at the back of the helmet
Fig. 31
3. Affix the foam cushioning present in your
Sena FOR SHARK kit (Bluetooth or Mesh)
to the back of the battery of your Intercom
Fig. 33
Fig. 31
4. Insert the battery (with foam) into the
space provided at the back of the helmet,
in accordance with Fig. 34 a/b/c, the foam
cushioning must be between the battery
and the shell.
5. Remove the textile cheek pads
according to the disassembly description
(page 18).
Fig. 33
Fig. 34a
Fig. 34b
Fig. 34b
21
Publicité
