Publicité
PINLOCK
(NMS-05S O NMS-05L,
®
DEPENDING ON HELMET SIZE)
(Available as standard or accessory/spare part)
1 ASSEMBLY
1.1 Disassemble the visor (see instructions
above).
1.2 Make sure that the inner surface of the
visor is clean and check that the pin adjustment
external levers are turned inwards (Fig.9).
MIN
1.3 Place the PINLOCK® inner visor on the
visor. The silicone profile of the PINLOCK®
inner visor must be in contact with the inner
surface of the visor.
1.4 Insert one side of the PINLOCK® inner
visor onto one of the two visor pins and hold
it in position (Fig.10).
1.5 Widen the visor and fasten the other side of
the PINLOCK® inner visor to the other pin (Fig.11).
1.6 Release the visor.
1.7 Remove the protective film from the
PINLOCK® inner visor and check that the
entire silicone profile of the inner visor
adheres to the visor.
MAX
Fig. 9
Fig. 10
Fig. 11
1.8 Assemble the visor on the helmet (see
instructions above).
2 CHECKING AND ADJUSTING THE
STRETCH
Check the correct PINLOCK® inner visor
assembly by opening and closing the visor
and ensuring that they do not move
with respect to each other. Should the
PINLOCK® inner visor not be tightly fixed
to the visor, simultaneously move, gra-
dually and not excessively, both external
adjustment levers turning them upwards,
to increase the stretch (Fig.9). The maxi-
mum stretch is achieved when the pin
adjustment external levers are placed
outwards.
WARNING: Dust between the two
visors may cause both surfaces to
scratch.
- Scratched PINLOCK® visors and inner
visors may cause reduced visibility and
must therefore be replaced.
- Regularly check the correct stretch of
the PINLOCK® inner visor to prevent
it from moving and scratching both
surfaces.
- If the helmet visor fogs up and/or
condensation forms between the visors,
check that the PINLOCK® inner visor is
both correctly assembled and stretched.
- An excessive and early stretch of the
PINLOCK® inner visor may result in
excessive adherence against the visor
surface and/or permanent deformations
with subsequent inability to correctly
perform any following adjustments.
- Intense sweating/breathing, use in
particular weather conditions (low
temperatures, high humidity, sudden
changes in temperature or heavy rain)
or intense and prolonged use may affect
the performance of the PINLOCK® inner
visor and cause fogging or formation of
condensation. In such cases, to restore
the system efficiency after using the
helmet, remove the PINLOCK® inner
visor from the helmet visor and leave
it to dry in warm and dry air. The same
procedure must be applied to the
helmet, which should be left to dry to
remove any humidity that may have
formed as a result of the conditions
described above.
11
Publicité
