Publicité
1.4 After having correctly fastened the
two adjustment snaps of the liner to
the longitudinal plastic support, fold and
spread the upper padding in the correct
position.
1.5 Wear the helmet and ensure that the
positioning and comfort suit your head.
If not, adjust it again.
WARNING : After adjusting the
position of the liner, put on and
fasten the helmet to check the correct
adjustment of the chin strap (see
specific instruction label under www.
nolan-helmets.com). Check also the
correct helmet fit on your head in riding
position setup, as well as its easy taking
off (see "CHOICE AND VERIFICATION
OF THE HELMET" instructions above).
EYEWEAR ADAPTIVE
1 CREATING SPACE FOR GLASSES
1.1 Remove the left cheek pad from the
helmet (see instructions above).
1.2 Remove the inner expanding foam
cheek padding (see instructions above).
1.3 Remove the upper part of the pre-
punched inner padding (Fig.26), then
properly reposition the remaining
part of the padding in the cheek pad.
It is recommended that you keep the
removed padding for any subsequent
reuse.
1.4 Assemble the inner expanding foam
cheek padding (see instructions above).
1.5 Reassemble the full cheek pad on the
helmet (see instructions above).
1.6 Follow these operations with the
right cheek pad padding.
2 REMOVING SPACE FOR GLASSES
2.1 Remove the left cheek pad from the
helmet (see instructions above).
2.2 Remove the inner expanding foam
cheek padding (see instructions above).
2.3 Properly insert part of the previously
removed padding into the cheek pad
fabric lining (Fig.26).
2.4 Reassemble the full cheek pad on the
helmet (see instructions above).
18
2.5 Follow these operations with the
right cheek pad padding.
WIND PROTECTOR
(Available as standard or accessory/spare part)
This accessory allows improved helmet
performance under certain conditions
of use.
The Wind Protector reduces unpleasant
infiltrations of air under the chin.
See Fig.27 for assembly and disassembly
instructions.
Fig. 26
Fig. 27
Publicité
