Publicité
REMOVABLE INNER COMFORT
PADDING
The comfort padding consists of:
- liner
- side cheek pads (right and left)
All components can be completely removed
and washed.
The cheek pads are also characterised by
removable inner expanding foam padding.
Deactivate the VPS and lift the helmet chin
guard to remove and/or install the comfort
padding (see instructions above).
1 DISASSEMBLING CHEEK PADS
1.1 Open the chin strap (see specific
instructions) and remove the chin strap
band from the elastic loop on the cheek
pad strap (Fig.15).
1.2 Pull the front of the left cheek pad
towards the inside of the helmet to
release the three buttons on its back (Fig.
16).
1.3 Remove the rear tab of the comfort
padding of the left cheek pad from the cavity
between the rear trim and the polystyrene
inner shell; then completely remove the
cheek padding from the helmet (Fig.17).
1.4 Follow these operations with the right
cheek pad padding.
Do not remove the polystyrene cheek pads
from the helmet shell.
2
DISASSEMBLING
EXPANDING FOAM PADDING OF THE
CHEEK PADS
To facilitate the washing of the inner comfort
padding components, the cheek pads of the
helmet are equipped with inner expanding
foam padding that can be removed from
the fabric lining. To remove the padding,
proceed as follows after disassembling the
cheek pads from the helmet (see instructions
above).
2.1 Unhook the three eyelets "A" of the rear
frame of the left cheek pad slot next to the
two snap buttons (front and rear) on the
back (Fig.18).
2.2 Slightly remove the inner expanding
foam padding from the fabric lining of the
left cheek pad (Fig.19).
2.3 Follow these operations with the right
cheek pad padding.
Fig. 15
made of expanding foam have been
removed from the cheek pads, ensure that
rear "B", front "A" and top "A" snap buttons
are correctly hooked to the rear frame of
the fabric lining of the cheek pads (Fig.20).
Otherwise,
Fig. 16
THE
INNER
appropriately.
WARNING: once the inner paddings
position
Fig. 17
Fig. 18
them
again
Fig. 19
15
Publicité
