Publicité
Steel Guard
19.3
ZIPPER MASCHINEN GmbH
www.zipper-maschinen.at
ZI-HS5TN, ZI-HS7TU
ASSEMBLY ZI-HS5TN & ZI-HS7TU
C.
Log tray left: Align the two mounting holes of log
tray left with the holes on the front of the splitter.
Insert a socket head cap screw M6×12 and a spring
washer 6 into the mounting hole on the right side,
another socket head cap screw M6×12 and lock
nut M6 on the left side and tighten both screws
firmly.
Then loosen the cup head bolt and nut on the
right side of the front leg, insert the open end of
support strut 1 onto the bolt and tighten the nut.
Connect the upper end of the support strut 1 with
the cross recessed pan head screw M6×12 and the
counter nut M6 with log tray 2 and tighten the
screw.
D. Connecting log tray right and left: Connect log
tray 1 and 2 with two screws M6×12 and lock nuts.
A.
Attaching front guard plates, left guard plate
and rear guard plates: Fix the front guard plate,
the left guard plate and two rear guard plates with
screws M6×12 and nuts to the log tray and the bot-
tom plate (1).
B.
Connecting top guard plates / rear guard plates:
Mount the two top guard plates with M5×12 bolts
and
nuts
to
Connect the top guard plates / rear guard plates
with the plate connectors and M5x12 bolts and
nuts (3).
the
vertical
plates
(2).
29
Publicité
