Publicité
19 ASSEMBLY ZI-HS5TN & ZI-HS7TU
Lifting Handle
19.1
Log Tray
19.2
ZIPPER MASCHINEN GmbH
www.zipper-maschinen.at
ZI-HS5TN, ZI-HS7TU
ASSEMBLY ZI-HS5TN & ZI-HS7TU
A.
Mounting the lifting handle: Attach the
lifting handle to the U-bracket with two
M6x16 screws.
A.
Fastening the guard bottom plate: Mount the
guard bottom plate to the rear guide plate and se-
cure it with the two socket head cap screws M6×12
and
the
Loosen the socket head cap screw and the large
washer on the wheel bracket, insert the open end of
the support strut 2 between the large washer and
the
wheel
bracket
Connect the upper end of support strut 2 to the
guard bottom plate with a cross recessed pan head
screw M6×12 and lock nut M6 and tighten.
B.
Log tray right: Align the two mounting holes of
log tray right with the holes on the rear of the split-
ter. Insert one socket head cap screw M6×12 and a
spring washer 6 into the mounting hole on the left
side, another socket head cap screw M6×12 and
lock nut M6 on the right side and tighten both
screws
Then loosen the cup head bolt and nut on the left
side of the front leg, insert the open end of support
strut 1 onto the bolt and tighten the nut.
Connect the upper end of support strut 1 by
means of a cross recessed pan head screw M6×12
and lock nut M6 with log tray 1 and tighten the
screw (2).
lock
and
tighten
the
screw.
firmly
nuts.
(1).
28
Publicité
