Valor Charlton & Jenrick PE2 Serie Instructions D'installation page 5

With 536CXBI—President Front
4. On each sides of the appliance, back off without
removing them, one screw at the top and one at the
bottom as illustrated.
5. Identify the left and right side brackets: the tab
should be at the top.
6. On each side of the appliance slide the side brackets
under the side screw heads. Tighten the screws.
7. Secure the side brackets by adding 1 screw to the
8. Slide the appliance into the cavity and center it
Top - RS View
9. Install the fuel bed in the fi replace—see appliance
10. Unpack the President cast front. The following piec-
Bottom - RS View
front of each bracket as illustrated.
laterally. Push it in so it hooks to the anti-tipping
fl oor bracket at the rear. The top baffl e and lower
bracket installed on the PE2 will project out of the
cavity.
and fuel bed's installation manuals.
es supplied with the cast front are not required for
this installation:
• Top Baffle—not used, recycle;
• Front hooks—need to be replaced, recycle;
• Barrier screen—can be left in place or removed.
Top Baffle
Front Casting with
Barrier Screen
Rear corner of the
appliance in the cavity
x
x
5