Valor Charlton & Jenrick PE2 Serie Instructions D'installation page 11

With 263RCB—Richmond Front
Installation
1. Unpack the kit and identify the brackets needed for
this installation as illustrated on the previous page.
2. On the appliance, install the fi nishing fl ange assem-
bly with 3 black screws provided.
3. On each sides of the appliance, back off without
removing them, two screws at the top and one
screw at the bottom as illustrated.
Top - RS View
Bottom - RS View
4. Either side brackets can be fi tted to the appliance.
Slide the side brackets under the screw heads just
released. Tighten the screws.
5. Unpack the Richmond Cast Front. The following
pieces supplied with the cast front are not required
for this installation:
• Bottom Baffle—not used, recycle.
• Fixing Brackets—to be replaced, remove from
the back of the cast surround and recycle.
• Barrier Screen—can be left in place or cut off
from its frame at the back. Recycle.
6. From the front of the cast surround, remove the 4
screws retaining its existing rear fi xing brackets.
x
Bottom Baffle
11