Blendtec COMMERCIAL Serie Manuel D'utilisation page 12

• Cut a hole in the countertop 4 ⅜" (11.1 cm) wide and 5 ⅞"
(14.9 cm) long (see the countertop hole template in Appendix
A). Ensure that the 4 ⅜" (11.1 cm) sides are parallel with the
machine operator.
Note: Double check to ensure that all space requirements and
measurements are correct BEFORE cutting.
• Place blender into the countertop; ensure the gasket is flat
against the counter surface.
3.2.3 CONNOISSEUR
TM
Preprogrammed Cycle Buttons
Note: Power switch is located on the front of the Connoisseur 825
Preprogrammed Cycles
Preprogrammed cycles run at varying speeds and durations, and
automatically stop. To start a cycle, press any preprogrammed
button. Press any cycle again to end that cycle. Hold
To program different cycles, see section 3.2.6 of this manual.
10
MODELS INTERFACE
Pulse
3.2.4 ADVANCED PROGRAMMING AND DIAGNOSTICS
Menu navigation tips
1. Press and
2. Press to scroll down and
3. To return to the main menu from any submenu area, tap the
until the main menu screen appears.
3.2.5 SELECTING THE DESIRED PROFILE
1. Press and
2. Press to scroll down to Profiles menu; press
3. Press to scroll to desired category; press
4. Press to scroll to desired profile and press
5. Press to activate profile. To cancel selection, press 'pulse'.
3.2.6 CHANGING PREPROGRAMMED CYCLE BUTTONS
Temporarily change cycle buttons
1. Press and
2. Press to scroll down to Blend Cycles, then press
to select.
3. Choose Standard Blend Cycles or Custom Blend Cycles.
4. Choose the desired blend cycle*.
5. Select the button to use for this blend cycle change, then
press . To cancel selection press
to pulse.
*To temporarily disable a button, select "Disable button" at
this step.
Note: After customizing a cycle to a number button, an asterisk will
appear after the profile name when returning to operation mode.
Loading a new profile on the blender will reset the profiles back to
default cycle buttons.
Permanently change cycle buttons
To permanently change the cycle buttons in a profile, export
the revised profile to a USB drive and import the profile on the
blender. Or, using Blend Wizard
profile, then export the profile to the blender.
for one second.
to select the desired function.
for one second to enter the menu.
for one second to enter the menu.
.
(my.blendtec.com), edit the
TM
to select.
to select.
to select.