Publicité
3.2 CONNOISSEUR™ 825 MODELS
CONNOISSEUR SERIES: ICB5 Connoisseur 825, ICB5
Connoisseur 825 Spacesaver
3.2.1 ABOVE COUNTER INSTALLATION
FIGURE 3
FIGURE 4
Make sure the blender is installed per the drawing in Figure 3.
Ensure the blender has 7.5" (19 cm) unobstructed
space surrounding the sides and back of the blender to
prevent overheating.
•
If installing a sound enclosure, allow a clearance of at least
5.5" (14 cm) from the sound enclosure to the wall and 26" (66
cm) from the countertop to any over-the-counter cabinetry.
•
Select a location that is near an electrical outlet. Also consider
proximity to ingredients and patrons as well as available counter
space.
•
Ensure there is enough room above and around the unit to
allow for unhampered movement of the sound enclosure.
3.2.2 IN-COUNTER INSTALLATION
FIGURE 5
MAKE SURE THE BLENDER IS INSTALLED PER THE DRAWING IN
FIGURE 5
.
•
Ensure electrical supply is accessible under the countertop.
•
The countertop can be no thicker than ¾" (1.9 cm) for
adequate ventilation.
•
If installing a sound enclosure, allow a clearance of at least
5.5" (14 cm) from the sound enclosure to the wall and 18" (45.7
cm) from the countertop to any over-the-counter cabinetry.
Note: Sound enclosure measurements are not applicable to the
Spacesaver
model
®
•
Ensure lower cabinetry allows adequate airflow.
•
There should be at least 3" (7.6 cm) of unobstructed space
below and around the motor. Cabinetry should not be closed;
it should allow air to flow freely from the outside to the inside
of the cabinet space.
•
If installing more than one blender, allow 16" (40.6 cm) of
center-to-center blender spacing.
9
Publicité
