Husqvarna Z448 Manuel D'utilisation page 20

7. Turn the ignition key to the stop position.
8. Remove the ignition key from the ignition when
you are away from the product.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule on
schedule. Refer to
page 20 .
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Use full throttle when you cut the grass.
• Move the product forward at low speed if the
grass is high and thick.
• Cut the grass in an irregular pattern.
• When the mulch kit is used, cut the grass more
frequently.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
* = The instructions are not given in this operator's
manual.
Maintenance
Make sure that there are no
damages on the product.
Do a check for damages on the
cutting deck.
Make sure that there are no
loose or missing parts.
Make sure that there are no
fuel or oil leaks from the prod-
uct.
Do a check of the tire pres-
sures.
Do a check of the level of the
engine oil.
Do a check of the hydraulic oil
level.
20
Maintenance
Before you do any
Daily mainte-
nance
Before After
*
*
*
*
X
O
X
• To get the best cutting result, cut the grass
frequently.
To do a 3-point turn
A correct turn will prevent damage to the lawn. The
goal is to turn when you move forward or rearward.
Do not turn in a tight circle on a stopped wheel.
1. Cut a row of grass.
2. Make a small turn (A) in the direction of the uncut
area of grass. (Fig. 48)
3. Pull the 2 control levers to the reverse position
and move the product rearward (B).
4. Push the control levers forward. To make a small
turn (C), pull harder on the control lever that is in
the direction of the row you have cut before.
5. Push the 2 control levers forward to cut the next
row.
X = The instructions are given in this operator's
manual.
O = Refer to the engine manual for instructions.
Maintenance schedule for the operator
Do mainte-
Maintenance interval in hours
nance at a
minimum of 1
time each
50
year
100 200 250 300
2237 - 002 - 22.03.2024
500