Husqvarna Z448 Manuel D'utilisation page 10

Conformity certificates............................................ 10
Introduction............................................................. 10
Safety......................................................................12
Operation................................................................ 17
Maintenance........................................................... 20
Troubleshooting...................................................... 27
Conformity requirements
Labels are placed on the engine and/or in the
engine compartment stating that the machine will
fulfill the requirements. Do not remove these labels.
Certificates can also be supplied with the machine at
Pre-delivery inspection and product
numbers
A pre-delivery inspection has been done of this
product. Make sure that you receive a signed copy
Service agent contact information:
This operator's manual is for product with product number / serial number:
Engine:
Transmission:
The product numbers are found on the type plate.
Product overview on page 10 for the
Refer to
location of the type plate.
Product description
This product is a ride-on lawn mower. The control
levers let the operator steer the product and adjust
Product overview
(Fig. 1)
1. Control levers
2. Parking brake
3. Tracking control
4. Hour meter
5. Fuel shut-off valve
6. Hydraulic release lever
7. Fuses
8. Fuel tank cap
9. Choke control
10. Ignition switch
10
Contents
Transportation, storage and disposal......................29
Technical data.........................................................31
Service.................................................................... 33
EU declaration of conformity...................................34
UK Declaration of conformity ................................. 35
Appendix .............................................................. 170
Conformity certificates
delivery or written in the Engine manual. Take care
of them as they are valuable documents.
To implement improvements, specifications and
designs can be altered without prior notification.
Introduction
of the pre-delivery inspection document from your
dealer.
/
the speed of the product. An hour meter shows how
many hours the product has been used.
Intended use
The product is made to cut grass on open and level
ground only. Do not use the product for other tasks.
11. Throttle control
12. PTO button
13. Fuel gauge
14. Deck lifting lever
15. Type plate
16. ROPS
Roll Over Protection Structure
(ROPS)
ROPS is a protective frame that decreases the risk
of injury if the product overturns. Use the ROPS
2237 - 002 - 22.03.2024