Publicité
on the leather honing wheel. Switch on the machine and distribute the grinding paste by pressing
the ground tool with circular movements on the eather honing wheel. These preperations are
sufficient for five to ten tools Then, you start again with a new layer of machine oil, followed by new
grindng paste. These measures increase the lifetime of the leather and the quality of your tools.
TIP: You can work in the free-handed mode for the polishing itself. You achieve a more precise
result if you keep the tool in the tool holder in the position in which you ground the tool.
12.4
Handling
12.4.1
Preparation
12.4.2
Settings
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Water reservoir:
Fill the water reservoir with water
The grinding wheel must be saturated with water!
The grinding wheel material absorbs water, so the level should be
checked regularly. Do not grind without water!
Empty the water reservoir regularly. Otherwise, particles of steel and
trimmed stone will accumulate and compress in the reservoir.
TIP: Such precipitations can be avoided if you place a magnet into the
water.
NOTE:
Once the grinding process is completed, lower or empty the
water reservoir to prevent the grinding stone from being in the water
for an extended period of time.
Leather honing wheel:
Cover the surface of the leather honing wheel with a thin layer of
grinding paste
Tourque:
The maximum torque to be transmitted can be set with the
adjustable torque knob.
Grinding angle:
The angle template helps to identify and maintain the cutting
angle on a variety of tools.
Place the tool (3) in the tool holder (2) and fix with the fixing
screws
Slide the tool holder over the universal holder (1)
The distance from the tool holder to the grinding stone is
intended to be as low as possible in order to control the
grinding process optimally!
Place the angle template (4) on the grinding stone with the
desired angle notch against the grinding stone and adjacent to
the universal holder
Adjust the positioning of the tool and the universal holder
height as necessary so that the sharpened edge of the tool is flat
against both the grinding stone (5) and the angle edge on the
angle template.
OPERATION
21
NTS250S_230V
Publicité
