Publicité
Ensure that unauthorised persons maintain an appropriate safety distance from the machine
and keep children away from the machine.
When working on the machine, never wear loose jewellery, loose clothing, ties or long, open
hair.
Hide long hair under hair protection.
Wear close-fitting protective clothing and suitable protective equipment (eye protection, dust
mask, ear protection, work gloves when handling tools).
Always work with care and the necessary caution and never use excessive force.
Do not overload the machine!
Shut down the machine and disconnect it from the power supply before carrying out any
adjustment, retrofitting, cleaning, maintenance or repair work. Before starting any work on the
machine, wait until all tools or machine parts have come to a complete standstill and secure
the machine against unintentional restarting.
Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
11.4
Electrical safety
Only use suitable extension cords.
A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from heat,
oil, sharp edges or moving parts.
Proper plugs and sockets reduce the risk of electric shock.
Water entry into machine increases the risk of electric shock. Do not expose machine to rain or
moisture.
The machine may only be used in humid environments if the power source is protected by a
residual current circuit breaker.
Do not use the machine if it cannot be turned on and off with the ON-OFF-switch.
11.5
Special safety instructions for this machine
Do not use damaged tools. Check tools such as grinding stones before each use and pay
special attention to be free of chippings and cracks. When you inspect the tool and put onto
the machine allow the unit to run at maximum speed for 1 minute, keep necessary safety
distance. Damaged tools usually break at this early stage.
The permissible speed of the tool must be at least as high as the maximum speed indicated
on the power tool. Accessories that rotate faster than permitted can break and fly around.
Never grind on the side surfaces of the grinding wheels. Grinding on the side surfaces can
burst the grinding wheels and cause them to fly apart.
11.6
Hazard warnings
Despite their intended use, certain residual risks remain. Due to the design and construction of the
machine, hazardous situations may occur when handling the machines, which are identified as
follows in these operating instructions:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working primarily depends on you!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
D A N G E R
W A R N I N G
C A U T I O N
N O T E
SAFETY
19
NTS250S_230V
Publicité
