Power Supply For The Z21 Digital Centre - Roco Z21 Manuel D'utilisation

2.3 Power Supply for the Z21 Digital Centre

As a power supply for the Z21 Digital Centre, please use exclusively the supplied AC adaptor (Art. No.
10851). Positively do not use a wound-core transformer!
With the Z21 Digital System, you can modify the voltage applied to your system at any time by soft-
ware. For this purpose, change to the menu "Z21 Settings" in the Z21 mobile app. Always make sure
to stay in 11 to 23 V range. Typical voltage ranges are from 14 to 18 V (for the gauges H0 and TT) and
approx. 12 V (for the gauge N).
Maximum input voltage for the Z21 Digital System is 24 V. The maximum track voltage is always 1 V
below the input voltage.
The Z21 Digital Centre is designed for loads of up to 3.2 A. If frequent power cuts occur in the system
due to overloads, please install a booster (see Page 46).
Note: To fi nd out the current power consumption of your system, check the menu point "Power
Centre" in the "Z21 Settings" menu of the Z21 mobile app.
Z21-Gebrauchsanleitung-A5quer_06052012_v20.indd 41 Z21-Gebrauchsanleitung-A5quer_06052012_v20.indd 41
Digital centre
Warning: Positively do not connect
the Z21 Digital Centre to Roco
amplifi ers Art. Nos. 10761 and
10764! Use these components only
on electrically separate layout parts
connected only by transition tracks.
Note: How to compute the power
consumption of an H0 system:
▶ Stationary locos with light:
approx. 100 mA
▶ Travelling locos depending on size
and load: 300 – 600 mA
▶ Illuminated coaches: approx. 30 mA
per minibulb (expect considerable
fl uctuations!)
▶ Digital coupling or smoke generator:
approx. 100 mA
▶ Digital switch drive or switch
decoder: approx. 500 mA as reserve
41
11.07.2012 16:55:27 11.07.2012 16:55:27