Publicité
16
Installation
• According to the polarity of the electrode to be used, insert
2.5.1 Connections for MMA Welding
EN
welding cables into the appropriate outlet and tighten them by
turning clockwise.
• Connect the earth clamp tightly to the workpiece as close as
possible to the welding area.
• TIG torch with a valve should be used.
2.5.2 TIG Welding Connections
• Connect the TIG torch power cable to the negative outlet and the
earth cable to the positive outlet of the machine.
• Install the Argon gas regulator onto the Argon gas cylinder.
• Connect the gas hose of the torch to the gas regulator.
Figure 6 : Connecting Gas Cylinder
USER MANUAL
ID 800E
Figure 5 : MMA Welding Connections
Figure 7 : TIG Welding Connections
www.magmaweld.com
ID 800E
OPERATION
3.1 User Interface
It shows the welding current in the left block. Welding mode settings are monitoring on
Left Block Current Display
this screen.
It shows the voltage value in the left block. When the current adjustment pot is pressed,
Left Block Voltage Display
the welding modes appear on the voltage screen. There are rutile, gouging, vrd and spot
modes.
Rutile mode should be selected when rutile/basic welding is desired.
Rutile Mode
Gouging mode should be selected when carbon gouging is desired.
Gouging Mode
It should be selected when short-interval electrode welding is desired. It ensures that the
Spot Mode
electrode breaks in a short time. The setting range is on/off.
It ensures that the idle voltage (voltage between the output terminals) is reduced below
Voltage Reduction
12V when the machine is running and no welding is performed. It may be required within
the framework of occupational health and safety rules. It is activated or deactivated by
turning the current adjustment pot left and right. The setting range is on/off.
Current adjustment is made by turning the current adjustment pot left and right. To select
Left Block Current Adjustment Pot
the welding mode, it is necessary to press the current adjustment pot. Each press switches
to the next mode.
www.magmaweld.com
Operation
17
EN
USER MANUAL
Publicité
