Publicité
10
Safety Precautions
The electrical current passing through any conductor generates zonal electric and magnetic fields
(EMF).
All operators must follow the following procedures to minimize the risk of exposure to EMF;
• In the name of reducing the magnetic field, the welding / cutting cables must be assembled and
EN
secured as far as possible with the joining materials (tape, cable ties etc.).
• The operator's body and head should be kept as far away from the welding / cutting machine
and cables as possible,
• Welding / cutting and electric cables should not be wrapped around the body of the machine in
any way,
• The body of the machine should not get caught between the welding / cutting cables. The source
cables must be kept away from the body of the machine, both being placed side by side,
• The return cable must be connected to the workpiece as close as possible to the work area,
• The welding / cutting machine should not rest against the power unit, ensconce on it and not
work too close to it,
• Welding / cutting work should not be performed when carrying the wire supply unit or power
unit.
EMF may also disrupt the operation of medical implants (materials placed inside the body), such
as pacemakers. Protective measures should be taken for people who carry medical implants. For
example, access limitation may be imposed for passers-by, or individual risk assessments may be
conducted for welders. Risk assessment should be conducted and recommendations should be
made by a medical professional for users who carry medical implants.
• Do not expose the machine to rain, prevent the machine from splashing water or
pressurized steam.
Protection
• Choose the welding / cutting method and welding machine for the welding work you are to
perform.
Energy Efficiency
• Select the welding / cutting current and/or voltage to match the material and thickness you are
going to weld.
• If you have to wait for a long time before you start your welding / cutting work, turn off the machine
after the fan has cooled it down. Our machines with smart fan control will turn off on their own.
• This device is not domestic waste. It must be directed to recycling within the framework of the
European Union directive and national laws.
Waste Procedure
• Obtain information from your dealer and authorized persons about the waste management of
your used machines.
WARRANTY FORM
Please visit our website www.magmaweld.com/warranty-form/wr for warranty form.
USER MANUAL
ID 800E
ID 800E
TECHNICAL INFORMATION
ID 800E, provides high performance with 800 Ampere power for a single user with its power blocks
1.1 General Information
consisting of 400 Amperes. It offers welding up to 400 amps with separate parameters for 2 users at the
same time. It is a powerful welding machine that has superior carbon gouging and rutile/basic electrodes
welding performance.
1.2 Machine Components
1
2
3
4
1- Left Block Current Display
2- Left Block Voltage Display
3- User Selection Button
4- Left Block Current Adjustment Pot
5- Left Block Earth Cable and Welding Cable Socket (+) 12- Mains Cabla Inlet
6- Left Block Earth Cable and Welding Cable Socket (-) 13- Handle
7- Right Block Earth Cable and Welding Cable Socket (+) 14- On / Off Switch
www.magmaweld.com
www.magmaweld.com
11
12
10
9
5
6
7
8
Figure 1 : ID 800E
9- Right Block Current Adjustment Pot
8- Right Block Earth Cable and Welding Cable Socket (-)
10- Right Block Voltage Display
11- Right Block Current Display
Technical Information
11
EN
13
14
USER MANUAL
Publicité
