Publicité
EN
Model Assembly
Horizontal Stabilizer Installation
1. Connect both elevator servo connectors to the extensions labeled ELEV in the
fuselage. Feed the excess servo wire into the fuselage, making sure the servo
plugs and excess wire are not visible when looking in the tail cone.
TIP: Note the correct polarity of the servo plugs: brown to brown, yellow to
yellow, and,orange to orange.
2. Press the horizontal stabilizer onto the fuselage, ensuring the alignment tab on
the stabilizer ts into the recess in the fuselage and no servo wires are pinched.
3. Insert two countersunk machine screws (M3 x 16mm) through the horizontal
stabilizer and into the rear holes in the fuselage.
Use a 2mm hex wrench, and do not overtighten the screws.
Vertical Stabilizer Installation
1. Connect the rudder servo connector to the extension in the fuselage labeled
RUDD. Feed the excess servo wire into the fuselage.
2. Press the vertical stabilizer into the slot in the horizontal stabilizer and the
fuselage, ensuring no servo wires are pinched.
3. Insert three countersunk machine screws (M3 x 16mm) through the vertical
stabilizer and into the fuselage. Do not overtighten the screws.
4
www.modellmarkt24.ch
M3 x 16mm
Viper 70mm EDF
M3 x 16mm
Publicité
