Publicité
and must comply with the minimum resistance requirements specified in the EN 795:2012 standard
(R ≥ 12 kN). Try not to distance yourself too much from this anchor point in order to limit the impact
of a possible pendulum fall.
- The tool-holder rings must not be used as anchor points or work positioning points under any
circumstances.
- After a fall or when the fall indicators have been activated (#6), the harness must be destroyed.
- The maximum rated load for the rescue harness function is 140 kg.
- This harness can be used by a person weighing less than or equal to 140 kg, provided that the
associated arrester systems comply with the normative requirements for arresting a fall with a mass
of at least 140 kg.
- Note that during rescue operations, there is a risk of suspension trauma.
- Before the first use of the full body and rescue harness, it is mandatory to carry out suspension
tests in a safe place on the fastening points to be used for the rescue operations (EN 1497: 2007)
(#2-B) in order to validate its expected effectiveness and comfort level (Adapted size - ease of
adjustments).
GENERAL CONDITIONS OF USE
- A periodic inspection carried out by a competent inspector is necessary to ensure the safety of the
user, which is connected to the maintenance of the effectiveness and resistance of the equipment.
A mandatory annual inspection will check the condition of the equipment and it can only continue
to be used on obtaining a written agreement.
- Do not expose these products to temperatures less than -30°C or more than 50°C.
- This equipment must not be used in any way contrary to these specifications and under no
circumstances should its limits be exceeded.
- Storage: the product must be stored in a dry and well-ventilated area, sheltered from any direct or
indirect source of heat and from ultra-violet rays. Drying wet equipment must be performed in the
same conditions.
- Cleaning and disinfection: exclusively with water and a neutral soap.
- Packaging: use rot-proof and watertight protective packaging.
- Transport: packaged and sheltered from impacts or pressure caused by the environment.
- The product must not be modified or repaired.
- Service life: Fall-protection PPE are designed to last for several years in normal conditions of use
and preservation. The service life depends on the use. Certain environments that are particularly
aggressive, marine, siliceous or chemical can reduce the service life of PPE. In these cases, special
care must be taken regarding protection and the inspections before use. The mandatory annual
inspection will validate the correct functioning of the mechanism and it can only continue to be used
on obtaining a written agreement from the manufacturer or its representative.
As concerns what has been mentioned above, the rough estimate of the service life of the products,
as recommended by the marketing authority, is 10 (ten) years.
- Ensure that the identification sheet and the maintenance monitoring table is kept up to date from
the time of the commissioning and during each inspection.
INTERPRETATION OF THE MARKINGS #7
Identification label :
(1) Product reference, (2) Pictogram requiring that the instructions be read before use, (3) Pictogram
showing the maximum rated load and size of the fall arrester and rescue harness, (4) Individual
Production No, (5) Date of manufacture, (6) Expiry date, (7) Reference standard and year of issue,
(8) Manufacturer's logo, (9) Address of the Marketing Authority, (10) Identification of the notified
body that intervened in the inspection and production phase, (11) CE Marking.
These products comply with the 2016/425 Regulation. They meet the requirements of the
harmonised standards EN361: 2002, EN1497: 2007. The declarations of conformity are
available on: www.neofeu.com.
10
Publicité
