Publicité
GB
IE
When using the surface nozzle (9),
pay particular attention to the heat
development in adjacent locations
of the cutting point. So that in cases
of doubt, no adjacent component is
overheated.
Spatula nozzle
Place the spatula nozzle (10) on the blow-
off pipe (4).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints and
lacquers can be removed with the paint
scraper (7). The spatula (10) itself is not
suitable for removing paint.
Grill lighter nozzle
Place the grill lighter nozzle (8) on the
blow-off pipe (4).
Change the device with the step switch
2) to level "II". Place the grill lighter
(
nozzle (8) below the charcoal. Make sure
that the openings of the grill lighter nozzle
(8) are not covered by charcoal as this cre-
ates heat accumulation in the unit, which is
a potential fire hazard In just a few minutes
the charcoal is ignited.
Never use other methods for ignit-
ing charcoal at the same time while
using the grill lighter nozzle (8).
Use the grill lighter nozzle (8) only
for the few minutes necessary to
ignite the charcoal.
Never use the grill lighter nozzle
(8) for any other application.
18
Cleaning/maintenance/
storage
Ask our service centre to carry out
any work that is not described in
these instructions. Do not try to re-
pair the device by yourself, unless
you have professional training. Use
only original parts.
•
Store the device in a dry place and out
of reach of children.
General cleaning and main-
tenance work
•
Always keep the device clean. Use a
brush or cloth for cleaning, but do not
use any cleaning agents or solvents.
Storage
•
Store the appliance in a dry place well
out of reach of children.
•
Give the device time to cool down
before you store the device in an en-
closed space.
We are not liable for damages caused by
our equipment. Insofar as these are caused
by improper repair or the use of non-origi-
nal parts or use contrary to instructions.
Publicité
