Publicité
5.11
User settings
1.
From the main interface, press
consultation interface.
In this interface, the time zone displays the code of the parameter to be interrogated and the
temperature zone displays the value of the parameter.
Press
or
to view each parameter.
2.
In the user parameters consultation interface, select a parameter and press
interface for setting this user parameter.
The parameter value (time zone) starts flashing.
3.
Press
or
to change the value of the current user parameter, then press
the change to the parameter value and return to the parameter consultation status.
List of user settings
N°
Power-down memory mode
C1
Refrigeration inlet and outlet water temperature
C3
compensation settings
Heater relay function selection
C4
Ambient temperature judgment value for starting heater
C5
Water temperature difference judgment value for
C6
restarting heater
Water temperature difference judgment value for
C7
restarting heater in manual mode
Circulation pump relay function selection
C8
Water temperature interval for temperature checks
C9
Water temperature difference for restart in heating mode 0°C~10°C
C10
Water temperature difference when stopped in heating
C11
mode
Water temperature difference for restart in cooling mode
C12
Water temperature difference when stopped in cooling
C13
mode
Dry contact function selection
C14
Audible warning
P1
Backlighting of the wired controller
P2
Setting the backlight mode
P3
Maximum brightness setting
P4
Setting the wired controller address
P5
70 | EN
5. USE
OF WIRE CONTROLLER
and
Description
for 5 seconds to access the user parameters
Range of values
1:On ; 0:Off
-4°C~0°C
0 : Off
1: Automatic
2 : Manual
-25°C~20°C
1°C~5°C
1°C~5°C
0 : Off
1: Automatic
2 : Manual
30~90min
0°C~10°C
0°C~10°C
0°C~10°C
0 : Off
1: In.grid mode
Off / On
Off / On
0: maximum brightness
1 : max / 50% / 15%
2 : max / 50% / off
30%~100%
01/02
to access the
to confirm
D. value
1 / on
0°C
0
5°C
5°C
2°C
0
60min
2°C
2°C
2°C
2°C
1 / on
on
on
1
100%
02
Publicité
