Publicité
4.6
Locking and unlocking
In the main interface, if no key is pressed for 30s, the control panel is locked automatically. When
the screen is locked, it displays "LOC".
Press the
and
the device unlocks, it emits a long beep.
4.7
Wifi connection
When the heat pump is switched off, press for 5 seconds.
WiFi logo will flash.
See section "7. Use via the mobile application", page 28 for more details on the wifi pairing
procedure.
4.8
Viewing status values
Press
and
for 3 seconds to check the status of your heat pump.
The parameter code appears and the value is displayed after 3 seconds.
Use the arrows
and
Press
to return to the main interface.
Code
External ambient temperature (°C)
01
Coil temperature (°C)
02
Compressor discharge temperature (°C)
03
Compressor return air temperature (°C)
04
Inlet water temperature (°C)
05
Outlet water temperature (°C)
06
(reserved)
07
Compressor operating frequency
A1
Fan speed
A2
Electronic expansion valve opening
A3
(reserved)
A4
(reserved)
A5
Historical fault 1 (earlier fault)
E1
Historical fault 2
E2
Historical fault 3
E3
Historical fault 4
E4
Historical fault 5 (recent fault)
E5
62 | EN
4. USE
OF CONTROL PANEL
simultaneously for 3 seconds to lock and unlock the control panel. When
to navigate between the different parameters.
Designation
and
to start WiFi pairing. The
Publicité
