Publicité
4.3
Functions overview
The indicators to the right of the control panel indicate the heat pump's other functions.
WiFi indicator
Indicates your Wifi connection status.
Flashes during pairing (see paragraph "4.7 Wifi connection", page 62). It remains on when
a connection is active. The first time it is switched on, the Wifi LED flashes rapidly.
Circulation pump indicator
Lights up when the circulation pump is active:
1. Disable mode: off,
2. Automatic mode: always bright when closed, off when disconnected.
3. Manual mode : flashes when closed, off when disconnected.
Heater pilot indicator
The RECH light is on when the heater is active:
1. Disable mode: off,
2. Automatic mode: always bright when closed, off when disconnected.
3. Manual mode : flashes when closed, off when disconnected.
4.4
Heat pump operating mode selector
By default, the heat pump is in heating mode.
To change the mode of use, when the heat pump is ON:
• Press the button
• Press the button again
• Press the button again
The different modes thus form a cycle:
Good to know:
The heat pump can take several minutes to change operating mode in order to preserve the
refrigerant fluid.
The maximum set temperature is 40°C.
4.5
Set temperature adjustment
Use the arrows
and
15-40°C (default 38°C). The refrigeration setting range is 4-35°C (default 32°C). The automatic
setting range is 4-40°C (default 35°C).
4. USE
OF CONTROL PANEL
, the heat pump will then switch to cooling.
, the heat pump will then switch to automatic.
, the heat pump will then switch heating.
to change the set temperature. The heating setting range is
EN | 61
Publicité
