Publicité
5.1
Installation
The remote control panel or wire controller is an option that allows you to control your heat pump
from a remote location.
To optimise the readability of the screen and its durability, place it away from direct sunlight, rain
and splashing water (IPX5 protection rating).
Follow the diagram opposite to connect the remote control panel.
5.2
Start
Initial interface
When the wire controller is switched on, all the patterns are displayed on the LCD screen. After 5
seconds, the buzzer sounds to enter the normal interface.
Start-up interface
Shutdown interface
5. USE
OF WIRE CONTROLLER
Motherboard
The start-up interface displays the default inlet water temperature
(the set temperature flashes for 5 seconds when the temperature
is set), the current mode, the start-up icon and the actual functions
(programmed start, defrost, antifreeze status, fan status, com-
pressor status, child lock status).
Example of display:
1. The current inlet water temperature is 30°C.
2. Start, heating mode and child lock
3. Fan motor and compressor are running
4. Enter defrost state
The shutdown interface displays the inlet water temperature, the
current mode and the current functions (programmed shutdown,
child lock).
Example of display:
1. The current inlet water temperature is 30°C.
2. Stop and heat mode
Controller
EN | 65
Publicité
