Publicité
5.5
Sound and light settings
Audible warning
Each time it is pressed, the buzzer emits a short beep. The user can deactivate the buzzer by
setting parameter P1 to 0. See "5.10 User parameters", page 25.
Backlighting
Set parameter P2 on the remote control panel to 1 to activate the backlight or to 0 to deactivate
the backlight. See "5.11 User settings", page 70.
By default, the backlight is at its brightest when the controller is in use.
After 15 seconds without pressing, the controller switches to half-wake mode and the backlight dims.
After 15s without pressing half-wake, the controller switches to standby mode. By default, the
lighting is at its minimum (15%). Parameter P3 can be used to switch off the screen in standby
mode (setting 2) or to keep the lighting at its maximum (setting 0).
Parameter P4 is used to modify the intensity of the maximum backlighting.
5.6
Setting the temperature
In the main interface, unlock the screen and then :
Press
or
to adjust the value. The "set" icon lights up.
5.7
Choice of operating mode
In the main interface, unlock the screen and then :
Press
to switch from one mode to the other.
5.8
Error display
5. USE
OF WIRE CONTROLLER
When an error occurs, the temperature display area will show the
error code. When there is more than one error, they are displayed
one after the other.
Example of display:
1. Heating is in progress, but error C5 occurs.
Refer to the table in section "8.3 Faults and malfunctions", page
36 for more details on faults.
EN | 67
Publicité
