Publicité
5.9
Time programming
Timer ON interface
Timer OFF interface
Procedure
Users can briefly press the
The adjustment steps are shown in the figure below:
Cancel the timer by pressing the key
68 | EN
5. USE
OF WIRE CONTROLLER
Programmed start displays the time and icon, as well as the set
temperature that will be executed after start-up. The other dis-
plays are consistent with the shutdown interface.
Example of display:
1. Heating will start in 5 hours.
2. Set the target temperature to 30°C.
The programmed stop displays the time and the icon, and the
other displays conform to the start-up interface.
Example of display:
1. The heating is on and the current inlet water temperature is
30°C.
2. Stop in 8 hours.
3. The fan motor and compressor are running.
to set the timer.
.
OR
Publicité
