Rear Panel - afx light MUSHROOM-2.0 Manuel D'utilisation

Effet de lumiere dmx multi-lignes a led avec telecommande
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DMX ADDRES SETTING
Every unit must have a specific starting address. During signal transmission, the unit will receive
channel control signals from the DMX controller through this starting address.
According to different requirements or for ease of use, the user can set several units to the same
address, or alternatively, he can set up a different address for every unit.
If more than one units have the same address, all of them will receive the same DMX channel signal
from the DMX controller. All connected units are jointly controlled, DMX controller can't control a
device separately.
If every unit has a different address, they will be separate and accept separate DMX512 control
signals through the separate DMX addresses, so that every unit will be controlled separately. this
method must be based on channel quantity of device to determine a starting address.
This device has 6 channels, so the starting address of the first device will be set to 1, the second is
7(1+6), the third is 13(1+12) and so on.
Address 13

REAR PANEL

1. IEC IN/OUT
2. Safety rope
3. DMX In/Out
4. LED display
MENU
Display
Addr
Enter
Chnd
Enter
Shnd
Enter
SLnd
Enter
Lost
Enter
(no DMX signal)
SP_A
Enter
EN
4
Address 7
Display
001-512
 / 
3CH
 / 
6CH
Sh1-Sh15
 / 
Mast
 / 
SL 1
soun
Auto
 / 
blac
A.001-A.100
 / 
Address 1
1
2
3
4
Function
Set DMX address
3 DMX channels
6 DMX channels
Built-in shows from 1-15
Master unit
Slave unit
Run sound mode if no DMX signal
Run Auto mode if no DMX signal
Blackout if no DMX signal
Auto show, speed low to fast
© Copyright LOTRONIC 2018

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

16-2640

Table des Matières