Thermador Professionalfi Serie Guide D'installation page 19

Place the burner cap gently on top of base so that the
2.
prongs of the burner base fit snugly into the groove of
the burner cap.
Check each burner to make sure there is no gap
3.
between the burner cap and burner base.
Gently try to move the burner caps from side to side
‒
to check if the caps are properly placed on the burner
bases.
When properly placed, each burner cap rests flat on
‒
top of its burner base, and completely covers the
star-shape of the burner base when viewed from the
top.
9.4 Placing the burner grates
For proper combustion do not use the rangetop without
the burner grates in place.
Place the burner grates flat-side down and align them
1.
into the rangetop recess.
The burner grates should rest flush against each other
2.
and against the sides of the recess.
9.5 Preparing the electric griddle
WARNING
To avoid risk of injury, never operate the griddle without
the griddle plate installed.
Testing the rangetop burners en-us
Check the griddle plate adjustment by pouring two
1.
tablespoons of water on the back of the griddle plate.
If the water does not flow to the front of the griddle, the
2.
griddle plate needs to be adjusted.
Lift off the griddle plate.
‒
Adjust the two screws under the back of the griddle
‒
plate. Start with one half turn counterclockwise of the
screws.
Replace the griddle plate and check the result.
‒
For further adjustment apply one-quarter turn until the
‒
water slowly flows into the grease tray.
10 Testing the rangetop burners
Testing the rangetop burners
Each burner must be tested for proper lighting and proper
Testing the rangetop burners
flame characteristics on the lowest and highest power
level.
Test all rangetop burners for proper ignition.
1.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol ⁠ .
Verify that the igniter/spark module clicks.
‒
Once the air has been purged from the supply lines,
‒
verify that the burner lights within four (4) seconds.
When the burner lights, turn the knob back to the off
position.
If any of the burners do not ignite, do not continue
‒
testing. Call Customer Service.
Test all rangetop burners for flame characteristics on
2.
the lowest setting.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol . Keep it pushed down until the
burner ignites.
Turn the knob quickly to the lowest setting.
‒
Verify that the flame is a minimum height of
‒
approximately ¼" (6 mm).
Verify that the flame is steady. The flame should not
‒
go out, lift or blow off of the burner. It should carry
over, or surround the entire burner.
Verify that the flame is the right color.
‒
→ "Flame characteristics", Page 20
If the flame goes out, does not carry over properly or
‒
is too large, contact Customer Service.
19