Thermador Professionalfi Serie Guide D'installation page 18

en-us Installation procedure
Slide the support brackets of the low backguard
2.
between the two rangetop chassis back panels.
Secure the back with 8 x 1½'' (38 mm) screws.
3.
Secure the front of the low backguard to the rangetop
4.
with 2 or 3 x ½" (12.7 mm) screws.
9½" 9½" 9½"
(239) (239) (239)
9.2 Setting the appliance
Attach the backguard, if applicable, before sliding the
1.
appliance into the final installed position.
→ "Installing the low backguard (purchased
separately)", Page 17
18
Lift and place the appliance in the countertop opening.
2.
Be careful not to pinch the power cord or gas inlet. Care
should be used not to scratch the countertop.
Make sure that the power cord is free and hanging
3.
loose.
The appliance must be level for proper performance.
4.
Replace the cooking grates, griddle plate, and burner
5.
caps. Ensure that the burner caps are correctly seated
on the burner bases.
9.3 Burner cap placement
The burner caps must be properly placed for the cooktop
to function properly.
If the burner cap is not properly placed, one or more of the
following may occur:
Burner flames are too high
¡
Flames shoot out of the burners
¡
Stainless steel discolorations
¡
Burners do not ignite
¡
Burner flames light unevenly
¡
Burner emits gas odor
¡
WARNING
To prevent flare-ups do not use the cooktop without all
burner caps and all burner grates properly positioned.
CAUTION
To prevent burns, do not touch burner caps or grates while
hot.
Turn the cooktop off and allow the burners to cool.
▶
Your rangetop has sealed STAR® burners. There are no
burner parts under the rangetop to clean, disassemble or
adjust.
Placing the burner caps
Each cap has a letter (B, D, or F) cast in the underside of
the cap that corresponds to a letter (B, D, or F) cast in the
burner base that is attached to the appliance.
Place each burner cap on its correct burner base per its
1.
corresponding letter designation.