Publicité
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check the
machine using this section. In most cases the problem can be solved quickly.
WARNING! Only perform the steps described within these instructions! All
further inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly qualified specialist if you cannot solve
the problem yourself!
Problem
Possible cause
1. Strong
1.1.
vibration and
noise
2. Bad cutting
2.1.
result
2.2.
2.3.
2.4.
2.5.
3. Charging time
3.1.
significantly
3.2.
exceeds the
rated charging
time
3.3.
4. Machine
4.1.
returns to
charging
4.2.
station more
frequently for
charging
5. Machine
5.1.
cannot dock in
the charging
5.2.
station
6. Machine does
6.1.
not mow within
the chosen
boundary
area/Machine
6.2.
reverses
or rotates
6.3.
erratically near
the boundary
wire
5059340856001_MNL_EN_V07.indd 34
5059340856001_MNL_EN_V07.indd 34
Cutting blades or bolts damaged
Working time is too short
Mowing area is too large
Cutting height is too low
Cutting blades are dull
Grass clippings or debris trapped
on the underside of the machine
No power to charging station
Poor contact between contact
pins and charging contacts
Ambient temperature higher than
40 °C
Battery is exhausted or old
Cutting blades are dull
Bad ground condition around the
charging station
Poor contact between contact
pins and charging contacts
Boundary wire of another robotic
lawnmower is too close
Boundary wire has been installed
with tight corners
Electric signal leakage due to
broken insulation of boundary
wire
34
Solution
1.1.
Check and replace the cutting
blades and bolts
2.1.
Increase the working time
2.2.
Increase the working time or adjust
the layout of the boundary wire.
2.3.
Set the cutting height to a higher
setting and gradually lower the
height
2.4.
Check and replace the cutting
blades
2.5.
Clean the underside of the machine
3.1.
Check the power connection
3.2.
Set the charging station on level
ground, and clean the contact pins
and charging contacts if needed
3.3.
Reposition the charging station or
wait until it cools down
4.1.
Replace battery by authorised
service centre
4.2.
Check and replace the cutting
blades
5.1.
Set the charging station on level
ground
5.2.
Clean the contact pins and charging
contacts
6.1.
Maintain a minimum distance of
1 metre between your boundary
wire and the neighbour's boundary
wire
6.2.
Check the boundary wire to ensure
the corners are smooth
6.3.
Repair damaged boundary wire
08/01/2024 12:40:08 pm
08/01/2024 12:40:08 pm
Publicité
