Publicité
•
To exclude any flowerbeds from the mowing area, use either of the following methods:
1. Maintain a distance of over 10 cm between the parallel wires (Fig. 3). This allows the machine to
recognize the boundary wire as a standard obstacle during cutting, causing it to bounce off as usual.
2. Keep the distance between the two parallel wires below 5 mm without crossing them, and position an
obstacle, like a large rock or pole, near position A as indicated in the illustration (Fig. 4). Ensure the
obstacle is surrounded by a flat 1 m x 1 m area, without any slopes, to allow the machine to smoothly exit
the circular space.
5059340856001_MNL_EN_V07.indd 16
5059340856001_MNL_EN_V07.indd 16
> 10 cm
Fig. 3
> 5 cm
Fig. 4
16
08/01/2024 12:40:03 pm
08/01/2024 12:40:03 pm
Publicité
