Publicité
•
Wipe the machine dry after cleaning.
Maintenance
Inspect and maintain this machine regularly based on below maintenance table.
Part
Task
Cutting blades
check
clean
replace
Blade bolts
check
clean
replace
Boundary wire
check
01 Cutting blades and blade bolts
WARNING: Wear protective gloves when working on the cutting blades (9).
Replace the cutting blade (9) if it becomes dull, bent or worn. Replace the blade
bolt when it shows signs of wear or damage. Use only the original spare parts
for replacement.
•
Loosen the blade bolts on the cutting blades (9) with a cross-head screwdriver by turning them anti-
clockwise (Fig. 29).
•
Fit the new cutting blades (9) and tighten the blade bolts clockwise with a torque of 1.3-1.5 Nm.
02 Boundary wire
•
Use wire cutters to remove the damaged section of the boundary wire (19), ensuring clean and straight
wire ends on both sides of the cut.
•
Insert the wire ends into the slots on the boundary wire connector (24).
•
Firmly close the blue cap on the boundary wire connector (24) using a pair of pliers.
Replacement parts
The following parts of this machine may be replaced by the consumer. Spare parts are available at an
authorised dealer or through our customer service.
5059340856001_MNL_EN_V07.indd 32
5059340856001_MNL_EN_V07.indd 32
Before/after
Every month or
each use
every 5 hours
x
x
x
x
Fig. 29
32
Every 3 months
Every year or
or every 50
every 200 hours
hours
x
08/01/2024 12:40:07 pm
08/01/2024 12:40:07 pm
x
x
Publicité
