Publicité
•
Avoid mowing wet grass as it can cling to the underside of the machine, posing a potential slip and fall
hazard.
After use
The machine and the charging station (12) are intended for continuous operation to autonomously carry out
the programmed mowing sessions. It is required only to switch the machine off when necessary, such as for
checking, cleaning or maintenance tasks.
EN Care and maintenance
The golden rules for care
WARNING! Press the STOP button (1) and wait for all parts to come to a
complete stop, and then switch the machine off and remove the main power
switch key (6) before carrying out any checking, cleaning or maintenance tasks.
WARNING! Disconnect the cables from the charging station (12) and unplug
the switching power supply (20) from the socket outlet before carrying out any
checking, cleaning or maintenance tasks.
•
Keep the machine clean. Remove debris after each use and before storage.
•
Regular and proper cleaning helps ensure safe operation and prolongs the life of the machine.
•
In the initial period of using the machine, inspect the cutting blades (9) once a week. If the wear during
this period has been minimal, extend the inspection interval as desired.
•
Do not operate it if any parts is found defective or worn. Replace worn parts as necessary or contact an
authorised service centre for repair before using the machine again.
WARNING! Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified specialist!
General cleaning
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this machine as they might be harmful to its surfaces.
NOTE: Use a fine abrasion paper or a brass brush to gently remove any dirt,
grass clippings, or debris that may have accumulated on the contact pins (11) or
charging contacts (4).
•
Wipe down all surfaces with a soft clean cloth.
•
Remove any grass clippings, debris, or buildup from the exterior surface of the machine.
5059340856001_MNL_EN_V07.indd 31
5059340856001_MNL_EN_V07.indd 31
31
08/01/2024 12:40:07 pm
08/01/2024 12:40:07 pm
Publicité
