Mounting The Tail Spur With Linkage; Mounting The Main Landing Gear - Reely SKY X-Trema 330L Notice D'emploi

o) Mounting the Tail Spur with Linkage
Apply the tail spur, mark and drill the holes and screw the spur to the
fuselage with self-locking screws 2.6 x 12 mm.
It is recommended that you remove the screws again after first assembly
and to apply a drop of liquid instant glue to each screw hole to increase
solidity.
Create a connection between the aluminium rudder horn installed to
the rudder and the rudder horn of the tail wheel with the sprints from
the construction kit. Also observe figure 3, item 1.
Figure 5
p) Mounting the Main Landing Gear
Mount the main landing gear on the fuselage with screws M4 x 20 mm
(the screws in figure 6a, item 2 are intended for the motor cowl
attachment and are only described in one of the following chapters).
Then install the wheel axes to the main landing gear (figure 6 b). Plug
the wheels onto the axes and secure them. Use the stop nuts on the
outside for this.
The construction kit also contains wheel covers. If required, they must
be installed in the same work step. Observe that the flattened sides of
the interim piece must point to the front/back. The wheel covers are
attached to the main landing gear with two screws M3 x 12 mm each.
Figure 6a
Figure 6b
28