Publicité
User manual
ADJUSTING ARC FORCE
It is advisable to set the Arc Force to the middle position (0) when starting to weld and to adjust it according to the welding results and the user's
preferences. Note: the Arc Force setting range is determined by the type of electrode selected.
HOT START SETTINGS
It is advisable to set the Hot Start feature low for thin sheet metal and to set it high for thicker and more difficult sheet metal (dirty or oxidised parts).
ENERGY
In addition to the weld bead's energy reading after welding, this mode, developed for welding with DMOS-supported energy control, allows the user
to change the following settings:
- The thermal coefficient according to the standard used: 1 for ASME standards and 0.6 (TIG) or 0.8 (MMA) for European standards. The displayed
energy is calculated taking into account this coefficient.
- The weld bead's length (OFF - mm): If a length is recorded, then the energy display is no longer in joules, but in joules/mm (the unit in the display
«J» will flash).
SAVING AND RECALLING JOBS
Accessible through the «JOB» icon on the main screen.
The active settings are automatically saved and recalled the next time you turn on the machine.
In addition to the active settings, it is possible to save and recall»JOB» configurations.
There are 500 JOBS for TIG welding processes and 200 for MMA welding processes. Memory storage is based on the current process settings, the
active settings and the user profile.
JOB mode
JOB mode allows you to create, save, recall and delete JOBs.
Quick Load - Recall JOBs from the trigger when not welding.
Quick Load is a non-welding JOB recall mode (20 JOBs max.) and is only available for TIG processes.
From a list of previously created JOBs, JOB recalls are done by short trigger presses. All trigger modes and welding modes are supported.
MultiJob - Recall JOBs using the trigger when welding.
From a MultiJOB list made up of previously created JOBs, this linking mode makes it possible to weld up to 20 JOBs in sequence with no inter-
ruption.
When the mode is activated, JOB N°1 in the list will be loaded and displayed. The trigger mode is forced to 4T.
During welding, this mode allows the JOBs in the uploaded list to be linked together by carrying out short presses on the torch's buttons.
The welding process is stopped by holding down the torch's buttons or, when the welding cycle is finished, JOB N°1 is reloaded for a future
welding sequence.
JOB 3 power surge
JOB 2 power surge
JOB 1
JOB 2
>0.5s
<0.5s
<0.5s
C5
From a previously created C5 list of 5 JOBs, this simple automation mode from the Remote Control connector allows the user to recall JOBs via
a PLC (see note on the website - https://planet.gys.fr/pdf/spdoc/fr/CONNECT_5.pdf).
Not available for 321 AC/DC.
Translation of the original
instructions
JOB 3
>0.5s
When the mode is activated, JOB N°1 in the list will be loaded and
displayed.
The JOBs recall sequence is looped: when the last JOB on the list
is reached, the next one will be JOB N°1.
Activate the welding process by holding down the torch's buttons.
TITANIUM
35
Publicité
