Publicité
Using the machine interface
Job memories and reminders
Can be accessed via the «JOB» icon on the main screen.
The settings in use are automatically saved and remembered the next time you turn on the machine.
In addition to the current settings, it is possible to save and remember so-called «JOB» settings.
There are 500 JOBS for the TIG processes, as well as 200 for the MMA process. Data storage is based on the current process
settings, the current settings and the user profile.
Job
This JOB mode enables JOBs to be created, saved, remembered and deleted.
Quick-Load
– Recall JOBs from the trigger when not welding.
Quick Load is a non-welding JOB recall mode (20 max) and only possible in TIG processes.
From a list of previously created JOBs, JOB recalls are done by short trigger presses. All trigger modes and welding
modes are supported.
MultiJob
Reminder of the JOBs to the trigger in welding.
–
From a MultiJOB list of previously created JOBs, this chaining mode allows you to weld by chaining up to 20 JOBs without
interruption.
When the mode is activated, JOB N°1 in the list is loaded and displayed. The trigger mode is forced in 4T.
During welding, this mode allows you to sequence the JOBs in the loaded list by briefly pressing the buttons on the torch.
Welding stops by pressing the buttons on the torch for a long time and once the welding cycle is complete, JOB N°1 is
recharged for a future welding sequence.
JOB 2 power surge
JOB 1 power surge
JOB 1
>0.5s
<0.5s
C5
From a C5 list of 5 JOBs previously created, this simple automation mode from the Remote Control connection allows
JOBs to be recalled via a PLC (see note on the website - https://planet.gys.fr/pdf/spdoc/uk/CONNECT_5.pdf).
16
JOB 2
JOB 3
<0.5s
>0.5s
When the mode is activated, JOB N°1 in the list is loaded
and displayed.
The recall of the JOBs in the sequence is in loop: when the
last JOB in the list is reached, the next one will be JOB N°1.
Welding is activated by pressing and holding the buttons on
the torch.
Publicité
