Publicité
TROUBLESHOOTING
PROBLEM
The chainsaw does
not work
The chainsaw works
discontinuously
Dry saw chain
The chain brake does
not work
Hot chain
The chainsaw jerks,
vibrates or does not
saw correctly
CAUSE
Kickback brake activated No
power supply Defective power
outlet Damaged extension
cord Defective fuse
Damaged power cable
External loose contact Internal
loose contact Defective
ON/OFF switch
No oil in the tank Air bleed
stuck in the oil tank seal Oil
outlet channel clogged
Problem with the switching
mechanism on the front
handguard.
No oil in the tank Air bleed
stuck in the oil tank seal Oil
outlet channel clogged Chain
not sharpened
Poor chain tension Dull chain
Worn chain Saw teeth facing in
the wrong direction
SOLUTION
Pull the hand guard back into position
Check power supply Try another
power source, change if necessary
Check cable, replace if necessary
Replace fuse
Contact Customer Service
Fill oil Clean oil tank closure Unblock oil
outlet channel
Contact Customer Service
Fill oil Clean oil tank seal Unblock oil
outlet channel Re-sharpen the bar or
change it
Adjust chain tension Sharpen or
replace bar Replace chain Saw teeth
are facing in the wrong direction
Publicité
