Publicité
Caring for and cleaning your appliance
CLEANING THE INNER AND OUTER SURFACES
• Cleaning the oven cavity with pyrolysis
WARNING
Remove the accessories from the oven before beginning pyrolysis cleaning. Before starting
pyrolysis cleaning, remove any large overspills, if any. Remove the excess grease on the door
using a damp sponge.
As a safety measure, cleaning by pyrolysis only occurs after the door locks automatically, it is then impos-
sible to unlock the door.
• Automatic self-cleaning
The programmer must display the time of day and must not be flashing. Select the self-
cleaning cycle with the function selector
Position the knob on this function
Select your pyrolysis cycle with the + and - knob depending on the degree of soiling of your oven.
Select between:
Confirm with the + and - knob, the pyrolysis cycle begins. At the end of the cleaning cycle, 0:00 will
appear on the display and the door will be unlocked. Turn the function selector back to 0.
* PyroExpress in 59 minutes.
This specific function uses the heat built up during a previous cooking cycle to quickly and
automatically clean the inside of the oven: it cleans a mildly dirty oven interior in less than
an hour.
The electronic oven temperature monitor determines whether the residual heat remaining
in the oven interior is sufficient to provide a good cleaning result. If this is not the case, a
90-minute ECO pyrolysis cycle will automatically begin.
18
12:05
Pyro
.
P01: PYRO 2H
P02: PyroExpress* or PYRO ECO 1H30 displays.
Pyro"Express 59 minutes"
When this indication displays on the screen, you can start a "PyroEx-
press in 59 minutes" cycle.
:
12:05
Pyro
2
00
H
12:45
2
00
H
Publicité
