Mounting The Elevator Unit - Reely Sky Hawk 2.0 Notice D'emploi

c) Mounting the elevator unit
• First pull off the protective foil of the double adhesive
tape on the bottom of the elevator unit (1) and on the
bottom of the unit support (2).
• First, only attach the elevator unit lightly to the end of
the fuselage so you can still adjust it. The borings in the
elevator unit must match exactly with the borings in the
fuselage, and the two distances B must also have the
same length.
• Once the fuselage is exactly adjusted, plug it into the
unit support (3) from above through the two borings and
screw it tight from the bottom with the two 2.0 x 8 mm
screws.
• With correct design, the elevator unit must be aligned
parallel to the wing (see sketch on the side).
In case of slight deviation, loosen the screws on the unit
support, place a thin strip of cardboard between the unit
and fuselage and tighten the screws again.
44
Figure 8