Reely Sky Hawk 2.0 Notice D'emploi page 48

• If you pull the control lever for the rudder and elevator functions (see figure 2, pos. 4) down, the elevator must
deflect to the top. In flight, the landing gear is pressed downwards and the model ascends.
• If the elevator reacts opposite to the function described above, you may change the direction of the elevator servo
with the reverse switch (see figure 2, pos. 7). There is a separate switch for each control channel. The elevator
direction is switched with the 2nd switch from the left (CH2).
• If you push the control lever for the rudder and elevator functions (see figure 2, pos. 4) up, the elevator must deflect
downwards. In flight, the landing gear is then pressed upwards and the model descends.
• This control function is required to put the model into a normal light position if it wants to ascend too much due to
a control error or a gust of wind.
48
Figure 14
Figure 15