Mounting The Elevator On The Fuselage; Mounting The Rudder - Reely Furious 3D Notice D'emploi

l) Mounting the Elevator on the Fuselage
Push the elevator into the intended slots from the rear as shown in figure 13. The rudder horn of the elevator points to the lower right when viewed from the rear.
Adjust the elevator so that the path "A" from the outer edge of the elevator to the outer edge of the aileron is the same length as "A*"
Then glue the aileron to the fuselage with suitable superglue.
m) Mounting the Rudder
Mount the rudder as shown in figure 14, using a longitudinal strip of hinged adhesive tape and a small strip of adhesive tape as already used for assembly of the
aileron and elevator on the other side.
40
A
A*
Figure 13
Figure 14