Use; Cleaning And Storage - Cleanmaxx SV1801 Mode D'emploi

• The fi lter should be replaced every 12 – 18 months; the UV-C lamp (12)
should be replaced every 12 – 24 months. If you have any questions about
spare parts, please contact the customer service department via our web-
site: www.dspro.de/kundenservice

Use

PLEASE NOTE!
■ The device should only be used if it has been completely and correctly assembled!
The dust container and the fi lter must be inserted and must not be damaged. If
the dirt were to get inside the motor unit, this could damage the motor.
■ Make sure that the safety switches of the UV-C lamp are not blocked!
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
1. Place the device down fl at on the surface which is to be cleaned.
2. Press the On / Off switch (2) to switch on the device. The device starts to vacuum and
the UV-C lamp (12) and the vibration head (11) switches on.
The vibration shakes up the surface which is to be cleaned and the dust which
is agitated is sucked in through the suction opening (8).
3. Guide the device very slowly and evenly over the surface to be cleaned.
4. After vacuuming, press the On / Off switch to switch off the device.

Cleaning and Storage

PLEASE NOTE!
■ Empty the dust container each time after you use the device. The fi lter must also be
regularly cleaned in order to prevent overloading of the motor.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These can damage the surface.
• As required, wipe down the motor unit (4) with a damp soft cloth. Then dry it with a
soft cloth.
• Wipe out the recess for the dust container (5) with a duster.
• Store the device in a dry, cool place that is not accessible to children and animals.
Cleaning the Dust Container and HEPA Filter
1. Press onto the dust container (5) to unlock it.
2. Reach into the recess in the dust container and pull it up and out of the motor unit (3).
3. Reach into the opening and pull the HEPA-fi lter out of the dust container.
4. Empty the dust container.
5. Wipe out the dust container with a dry duster if necessary.
19 EN