Parkside Performance 445977 2307 Traduction Des Instructions D'origine page 57

Maintenance and
cleaning
Maintenance and cleaning
work must always be carried
out with the motor switched
off and the batteries removed.
Danger of injury!
Leave any maintenance and servic-
ing work not covered by this man-
ual to our Service-Center. Use only
original spare parts.
Allow the machine to cool down
before all maintenance and clean-
ing works. Danger of burn injuries!
Use cut-protection gloves
when handling the chain or
the chain bar. Risk of cuts!
Switch off the device and remove
the battery before carrying out any
maintenance work.
Maintenance Interval Table
Machine part
Components of
the chain brake
Sprocket chain
wheel­(20)
Saw chain­(6)
Guide bar­(7)
Guide bar­(7)
Automatic oil
system
Action
Check,­replace­if­required
Check­for­wear/indentations,­
replace if necessary
Check­oil,­regrind­or­replace­
if required
Check,­clean and oil
Turn around
Check,­clean­oil­aperture­if­
necessary
Cleaning
•­ Clean­the­machine­thoroughly­after­
every­use.­In­this­way,­you­extend­the­
life of the machine and avoid accidents.
•­ Keep­the­gripping­handles­free­of­pet-
rol,­oil­or­grease.­Clean­the­gripping­
handles,­where­appropriate,­with­a­
moist cloth soaked in soap. Use no sol-
vents or petrol for cleaning!
•­ Clean the saw chain after every use. Use
a paint brush or wipe for that. Do not use
any liquids to clean the chain. After clean-
ing,­oil­the­chain­lightly­with­chain­oil.
•­ Clean­the­ventilation­slots­and­the­
surfaces of the machine with a paint
brush,­whisk­or­dry­cloth.­Do­not­use­
any liquids for cleaning.
Maintenance intervals
Regularly carry out the maintenance
operations listed in the following table.
The­life­of­the­saw­is­extended­by­regular­
maintenance of your chainsaw.
Furthermore,­you­get­optimum­cutting­per-
formance and avoid accidents.
Before every
use





GB MT
After 10 hours
of operation

57